MSDS No:	220
Revision No:	005
Date:	05/09/97

MATERIAL SAFETY DATA SHEET

HILTI, INC.:
P.O. Box 21148
Tulsa, OK 74121
Ph: 1 800 879 6000
Emergency No.: 1 800 879 4444

PRODUCT NAME: Aseol Litea EP 6-076

DESCRIPTION: Lubricating grease based onlithium soap, mineral oil and additives

INGREDIENTS AND EXPOSURE LIMITS

INGREDIENTS:	CAS NUMBER:	PEL:	TLV:	STEL:
Petroleum grease	NE	NE	NE	NE

PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. These are 8 hour time-weighted averages unless otherwise indicated by "C" (Ceiling) or "STEL" (Short Term Exposure Limit). NE = None Established.

PHYSICAL DATA

APPEARANCE AND ODOR: Green paste, petroleum odor	pH: Not Determined
BOILING POINT: Not Applicable	MELTING POINT: Not Applicable
VOC CONTENT: 0 g/l	VAPOR PRESSURE: Not Applicable
VAPOR DENSITY: Not Applicable	EVAPORATION RATE: Not Applicable
SOLUBILITY IN WATER: Insoluble	SPECIFIC GRAVITY: 0.9

FIRE AND EXPLOSION HAZARD DATA

FLASH POINT: >180°C

FLAMMABLE LIMITS: Not Applicable

EXTINGUISHING MEDIA: Water spray, dry chemical, foam or carbon dioxide.

SPECIAL FIRE FIGHTING PROCEDURES: None known. Use water spray to soak cartons in order to keep fire from spreading.

UNUSUAL FIRE AND EXPLOSION HAZARDS: None Known. Thermal decomposition products can be formed. See below.

REACTIVITY DATA

STABILITY: Stable. INCOMPATIBILITY: Strong oxidizers.

HAZARDOUS DECOMPOSITION PRODUCTS: Thermal decomposition products can be produced when subjected to combustion including carbon monoxide and carbon dioxide.

HAZARDOUS POLYMERIZATION: Will not occur.

CONDITIONS TO AVOID: Contact with strong oxidizers.

HEALTH HAZARD DATA

KNOWN HAZARDS: Can cause eye and skin irritation. Prolonged and repeated overexposure to oils and greases can lead to dermatitis.

CARCINOGENICITY: No ingredients are classified by IARC, NTP, or OSHA as known or potential carcinogens.

PRIMARY ROUTES OF EXPOSURE: Dermal.

SIGNS AND SYMPTOMS OF EXPOSURE: None expected. Chronic skin exposure can cause dermatitis.

MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: None anticipated.

EMERGENCY AND FIRST AID PROCEDURES

EYES: Flush with plenty of water.

SKIN: Wash with soap and water. Launder contaminated clothing before reuse.

INHALATION: Move victim to fresh air.

INGESTION: Do not induce vomiting unless directed to by a physician. Seek medical attention.

OTHER: Referral to a physician is recommended if there is any question about the seriousness of the injury/exposure.

CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENT

VENTILATION: General (i.e. natural or mechanically induced fresh air movements that maintain vapor concentrations below recommended exposure limits).

EYE PROTECTION: Safety glasses are required in most industrial settings.

SKIN PROTECTION: Not required. Gloves recommended.

RESPIRATORY PROTECTION: Not required.

PRECAUTIONS FOR SAFE HANDLING AND USE

HANDLING AND STORING PRECAUTIONS: Avoid prolonged or repeated contact with skin. Avoid high temperatures. Water contamination should be avoided.

SPILL PROCEDURES: Wipe up or absorb on suitable material. Keep away from sanitary sewers and other waterways.

REGULATORY INFORMATION

HAZARD COMMUNICATION: This MSDS has been prepared in accordance with the federal OSHA Hazard Communication Standard.

HMIS CODES: Health 1, Flammability 1, Reactivity 0, PPE A

DOT SHIPPING INFO: Non-regulated

TSCA INVENTORY STATUS: Chemical components listed on TSCA inventory.

SARA TITLE III, SECTION 313: This product does not contain any toxic chemicals which are subject to reporting under Section 313 of SARA Title III (40 CFR Part 372).

WASTE DISPOSAL METHODS: Consult with regulatory agencies or corporate personnel for disposal methods that comply with local, state, and federal health and environmental regulations.

HEALTH / SAFETY CONTACTS:
Steve Gerrard (x6309)
Jerry Metcalf (x6704)

The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or warranty of any kind expressed or implied is made with respect to the information provided.